Orolia Spectracom VelaSync 1232, User Manual

Page: 182 / 268

Too Few GPS Sat, Major, Cleared
GPS Antenna Problem
GPS Antenna OK
GPS Receiver Fault
GPS Receiver Fault Cleared
Under the GPS Events tab, you can also configure Minor and Major Alarm Thresholds
for GNSS fault events; see "Configuring GPS Notification Alarm Thresholds" below .
4.4.2.3 System Tab: Events
Minor Alarm Active
Minor Alarm Inactive
Major Alarm Active
Major Alarm Inactive
Unit Reboot
Timing System Software Error
Timing System Hardware Error
High Temperature Temperature alarms are based on the CPU temperature., Minor
Alarm
High Temperature, Minor, Cleared
High Temperature, Major Alarm
High Temperature, Major, Cleared
4.4.3 Configuring GPS Notification Alarm Thresholds
VelaSync allows you to configure Minor and Major alarm thresholds for the GNSS receiver.
This is done by setting the minimum number of satellites the receiver can track for a set
time before an alarm is triggered. If both conditions are met, i.e. the reception quality falls
below the set number of satellites for the set amount of time, an alarm is triggered.
The alarm notification feature described below allows you to be notified of a potential
reception issue BEFORE the GNSS reference becomes invalid. This may be useful e.g., to
notify system operators of a deteriorating signal reception before VelaSync loses the
GNSS reference.
Note that VelaSync itself has a pre-defined minimum number of satellites that must be
tracked in order for GNSS to be considered a valid reference. The minimum number of
satellites depends e.g., on your receiver mode, the GNSS signal reception in the area
where your antenna is located, and the type of receiver in your unit. In Stationary mode,
170
CHAPTER
4
•
VelaSync 1232 User Manual Rev. 4
4.4 Notifications