8
Switching on the power
After completing the internal installation work of the device and fitting the front cover to the back plate, the power supply must be applied. When the power supply is
connected, the red LED will start flashing.
Quick Reference Programming Guide
The code lock can operate one entrance to the property. Up to 1000 magnetic cards and user access codes can be programmed in the lock memory. It is possible to
program 3 different methods of lock activation:
a) entry to the property only with an authorised proximity ID card,
b) entry to the property with an authorised proximity card and a digital access code,
c) entry to the property by means of an authorised proximity card or a digital access code.
The default MASTER CODE (administrator code) is "9999". MASTER CODE must be a 4 - 6 digit number.
User PIN code can be 4 - 6 digits long and can be in the whole range 0000 - 999999 excluding codes 1, 2, 3, 4.
To enter the programming mode
In standby mode, enter (within 5 seconds):
* Master code #
The red LED lights up. If no button is pressed within 30 seconds, the device will exit
programming mode.
To exit from the programming mode
*
Note that to undertake the following programming the master user must be logged in.
After each step that completes the operation, if the change is to be saved and programming is to be exited, press the "*" button.
If you want to continue programming you can go directly to the next step, after completing the operation press "*" button the change will be saved and
programming mode will be exited.
To change the master code
0 New code # New code #
*
Once accepted, the red LED will flash.
User operation mode for access -
(Note: only one can be selected)
Access only with card (proximity tag)
3 0 0 #
Access by card (proximity tag) and PIN code
3 0 1 #
Access by card (proximity tag) or PIN code
3 0 2
# factory mode (default)
Activation via card (proximity tag) or code PIN (302#)
In this mode, the user can open the door either with a card (proximity tag) or with an access code PIN (alternatively). To do this, press the key
sequence 302# in programming mode and then add users.
Detailed programming instructions
Add and delete users in card (proximity tag) or PIN code mode
Adding user access codes
1 User ID number # PIN code #
The user ID number must be a 3-digit number between 000 and 999. Not to be
confused with the user access code. User ID numbers must be different for each
proximity tag. The PIN number can be any 4-6 digit number between 0000-9999
except the code "1234". Users can be added sequentially without entering
programming mode each time.
1 User ID number 1 # PIN code # User ID number 2 # PIN code #
…
User ID
number
„
n
”
# PIN code #
Deleting user access codes
2 User ID number # PIN code #
User codes can be deleted sequentially without exiting the programming mode each
time.
Changing user access code
(This action must be performed out of the programming
mode).
* ID number # Old PIN code # New PIN code # New PIN code #
Adding and deleting user ID cards
Method 1
Automatic assignment of ID numbers to users by the
system
1 Read card #
Cards can be added sequentially without exiting programming mode.
Method 2
Manual assignment of ID numbers to users. Only 1 user
can be assigned to a single card (proximity tag).
1 ID number # Read card #
Deleting the user card using the card number
2 Read card #
Cards can be added sequentially without exiting programming mode.
Deleting the user card using the user number
2 User ID number #
Adding and deleting users in card (proximity tag) and PIN code (301#) mode
