2
The output nozzle gets very hot during operation (300 degrees C). Keep flammable materials at
least 1 metre away from the nozzle.
Always allow your fog machine to cool down before attempting to clean or service it.
Never add flammable liquids of any kind (oil, gas, perfume) to the fog liquid. Pay attention to all
warning labels and instructions printed on the exterior of your fog machine.
Use only the high-quality, water-based fog liquid that your dealer recommends. Other fog liquids
may cause clogging or spitting.
Always make sure there is sufficient liquid in the fog liquid tank. Operating this unit without liquid
will cause damage to the pump as well as over-heating.
In case of malfunction, discontinue use immediately. Drain all fog liquid from the tank, pack the
unit securely (preferably in the original packing material), and return it to your dealer for service.
Always drain the tank before shipping or transportation.
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with
skin or eyes rinse thoroughly with water.
Unpacking and Setup
Open the shipping carton and verify that all equipment necessary to operate the system has arrived
intact and undamaged. If anything is broken or missing, please contact your dealer.
Remove all packing materials from the shipping box. Ensure that any foam and plastic padding is
removed, especially in the nozzle area.
Place the fog machine on a flat surface and remove the fog tank cap.
Fill with only with dealer-recommended high-quality fog liquid. Any other type of fluid can damage
the unit.
Place the cap back on the liquid tank.
Attach the Remote Controller cable to the controller input on the back of the machine.
Operating Instructions
Plug the power cord into a grounded A/C electric outlet. (If necessary, turn the power switch on
the rear of the fog machine to position 1.)
Warm-up is complete when the green lamp lights up on the Remote Controller.
To release fog, press the button on the Remote for the desired length of time.
The light on the Remote lamp will cycle on and off as the machine re-heats to the proper
operating temperature.
The fog machine can be placed at floor level or mounted overhead with a bracket. If the unit is to
be suspended with a bracket, ensure that fog does not spray directly at anyone.
Regardless of how the unit is installed, it should not be tilted at a greater than 15 degree angle.
Important:
Always monitor the tank fluid level while fogging – running the fog machine with no fluid
can permanently damage the unit.
