11
LOADING THE FILM
The film roll can be loaded on the carriage mandrel from
either end of the roll. When using tacky film, please verify
that the inward tacky surface of the film is inward on the
load.
1. Disconnect power (turn off power switch).
2. Swing up the top mandrel spool.
3. Put the roll of film on the bottom mandrel.
4. Install the top mandrel on top of the roll to prevent
upward movement.
5. Pull the handle marked PULL TO OPEN to open film
distributor cradle.
6. Pass the roped tail of the film through opening (as
shown on the film quick threading pattern DWG. # 418180
Fig.1).
7. Close the film distributor cradle by pushing bar marked
PUSH TO CLOSE.
8. When the film feeding is completed (fig. 2) – turn the
power switch on.
9. Peel off the first few winds of the film (multistrech will
run due to displacement of the dancer roller) and fix the
film end onto the load.
The system is now ready to begin the first wrapping
cycle.
ADDITIONNAL SPACER WASHER
(IF NEEDED ONLY)
The roll of film may be slightly different from time to time,
so you might have to change the bottom spool spacer
(washer). The only thing you have to do is to add or
remove the spacer washer under the bottom spool. With
the machine their is 1 washer under the bottom spool
(432322), and you have received with the machine 2 extra
washer to be use if needed.
Note: The bottom of the film should not be lower than
the chamfer of the aluminum strip as shown on the
drawing below.
