Arm Mounted:
1.
Take the arm from the package. Take apart the arm.
2.
Open the frame and take the LED module from the fixture. Be careful with the LED module, Keep them in the safety and cleanly.
3.
Each Rod with a M10 nuts. Let the rod go through the Mounting Plate B ,Gasket A , Fixture, & Mounting plate A. Rotate the nuts, and let the rods
securely on the fixture
4
．
Secure the LED module & frame on the fixture.
5
．
Put the arm, Gasket B & Arm Base on the rods.
6. Mounted the whole fixture to the Pole (Showed in the below)
7. Put the flat washers, spring washers and the M10 nuts on the rods. Rotate the nuts to securely the fixture on the pole.
(If the arm was assembled on the fixture, then you can take step 6 & 7 only).
Wiring
Universal voltage driver permits operation at 100V to 277VAC, 50 or 60Hz except fixtures factory ordered with a 120V photocell (/PC).
1. Connect the black fixture lead to the (L) LINE supply lead.
2. Connect the white fixture lead to the (N) COMMON supply lead.
3. Connect the bare copper Ground wire from fixture to supply lead.
Cleaning & Maintenance
Caution: Be Sure fixture temperature is cool enough to touch. Do not clean or maintain while fixture is energized
1.
Clean glass lens with non-abrasive glass cleaning solution
2.
Do not open fixture to clean the LED. Do not touch the LED.
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation,
operation or maintenance.
Gasket B
Arm
M10 Nuts
Gasket A
Housing
Frame
LED module
Mounting
Plate A
Cable Gland
Mounting
Plate B
M10 Rod
Arm Base
Flat Washer
Spring Washer
M10 Nuts
Pole Cap
Pole
ARXS1-060L
ARXS1-090L
