English
- 8 -
Note:
When receiving DTV channels (Mpeg4 H.264) or while in Media Browser mode, output will not
be available via the scart socket.
VGA Input
5.
is for connecting a personal computer to the TV set.
Connect the PC cable between the
PC INPUT
on the TV and the PC output on your PC.
SPDIF Out
6.
outputs audio signals of the currently watched source.
Use an
SPDIF cable
to trasfer audio signals to a device that has SPDIF input.
Viewing the Connections - Side Connectors
The CI Slot is used for inserting a CI card. A CI card allows you to view all the channels
1.
that you subscribe to. For more information, see “Conditional Access” section.
Side USB input.
2.
Video Input is used for connecting video signals of external devices.Connect the video
3.
cable between the VIDEO IN socket on the TV and the VIDEO OUT jack on your device.
Audio Inputs are used for connecting audio signals of external devices. Connect the audio
4.
cable between the AUDIO INPUTS on the TV and the AUDIO OUTPUT jacks on your device.
Note: If you connect a device to the TV via the VIDEO INPUT, you should also connect your
device with an audio cable to the AUDIO INPUTS of the TV to enable audio.
The headphone jack is used for connecting an external headphone to the system.
5.
Connect to the HEADPHONE jack to listen to the TV from headphones.
Power Connection
IMPORTANT: The TV set is designed to operate on 220-240V AC, 50 Hz.
After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
•
mains. Plug the power cable to the mains socket outlet.
Aerial Connection
Connect the aerial ,cable TV plug to the
•
AERIAL INPUT (ANT)
socket located at the rear of the TV.
DI
H
M
1
SPDIF
Coax.OUT
DI
H
M
2
Aerial or Cable
USB Connection
You can connect a USB hard disk drive or USB memory stick to your TV by using the USB inputs of the TV.
•
This feature allows you to play fi les stored in a USB drive or record programmes.
2.5” and 3.5” inch (hdd with external power supply) external hard disk drives are supported.
•
To record a programme, you should fi rst connect a USB disk to your TV while the TV is switched off. You should
•
then switch on the TV to enable recording feature. Otherwise, recording feature will not be available.
IMPORTANT !
You may back up your fi les before making any connections to the TV set in order to avoid any possible data
•
loss. Note that manufacturer will not be responsible for any fi le damage or dataloss.
It is possible that certain types of USB devices (e.g. MP3 Players) or USB hard disk drives/memory sticks
•
may not be compatible with this TV.
01_MB62_[GB]_woypbpr_IDTV_TC_NICKEL17_1900UK_32906W_10078529_50216712.indd 8
01_MB62_[GB]_woypbpr_IDTV_TC_NICKEL17_1900UK_32906W_10078529_50216712.indd 8
06.04.2012 19:47:58
06.04.2012 19:47:58
