Orima OR 640 VX, Instruction Manual, Page: 12 / 20

ELECTRICAL CONNECTION and SECURITY
1.
2.
3.
4.
5. Electrical cable shouldn't touch the hot parts of the appliance.
GAS CONNECTION and SECURITY
1. Fit the clamp to the hose. Push one of the hose until it goes to the end of the pipe
by heating in boiling water, and tighten the clamp with screw driver.
2. For the sealing control; ensure that the buttons in the control panel are closed,
but the gas cylinder is open. Apply some soap bubbles to the connection.
If there is gas leakage, there wil be foaming in the soaped area.
RE-INSPECT THE GAS CONNECTION.
2
2 - INSTALLATION OF YOUR COOKER
If your electric supply cable gets defective, it should definitely be replaced by the authorized service or qualified electricians in
order to avoid from the dangers.
Your cooker requires a 16 Amp fuse. If necessary, installation by a qualified electrician is recommended.
Your cooker is adjusted in compliance with 230 Vac 50 HZ electric supply. If the mains is different from this specified value, contact your authorized
service.
Electrical connection of the cooker should only be made by the sockets with earth system installed in compliance with the regulations. If there is no
proper socket with earth system in the place where the cooker will be placed, immediately contact a qualified electrician. Manufacturer shall never be
responsible from the damages that will arise because of the sockets connected to the appliance with no earth system. If the ends of the electrical
connection cable is open, according to the appliance type, make a proper switch installed in the mains by which all ends can be disconnected in case
of connecting / disconnecting from / to the mains.
DO NOT MAKE GAS HOSE and ELECTRICAL CABLE OF YOUR COOKER GO THROUGH THE HEATED AREAS,
SPECIALLY THROUGH THE REAR SIDE OF THE COOKER. DO NOT MOVE GAS CONNECTED COOKER. SINCE THE
FORCING SHALL LOOSEN THE HOSE, GAS LEAKAGE MAY OCCUR.