Function Setting
功能設定
5
5.
左右送風
:
按下左右送風鍵
，風扇以自動左右搖擺模式送風。如欲停止自動左右搖
5.
OSC(LEFT/RIGHT): Press the key to allow the Fan to LEFT/RIGHT oscillate the
擺送風，再按此鍵一次。
wind direction. To stop the oscillation, press the key again.
6.
定時關機
:
在風扇運行時，按下定時設置鍵 ，選定
9
個不同的自動關機時間，分別
由
1
至
9
小時，
LED
定時設置顯示燈將會亮起，
LED
顯示屏將會顯示所選關機時間。
6.
OFF
TIMER: When the Fan is running, pressing the key to set desired auto power
off time, There are 9 time intervals, from 1-hour to 9-hour. The LED of timer will be
on and displayed the off time setting on the LED screen.
4.2. ECO
功能
:
-
室內溫度低於
18°
C
時，顯示屏顯示
"LO"
，高於
35
°
C
時，顯示屏顯示
"HI"
，不
再顯示當時室內溫度。
-
在遙控器上按
ECO
模式按鈕，直接進入風速隨室內溫度變化的狀態，再按一次，
則退出此狀態，恢復到原本狀態。
- ECO
模式下，按開關/風速鍵 則取消
ECO
模式並自動轉為正常風且可調節風速。
4.2. ECO Function:
- When the fan is running, long press the mode key for more than 3
seconds to enter the ECO mode. The wind speed will be change
automatically according to the indoor temperature in ECO mode.
- In ECO mode, the LED display shows "EC", and the indoor temperature is
displayed alternately every 5 seconds. If there is a timer setting, "EC",
room temperature, and timer are displayed alternately every 5 seconds.
- In ECO mode, the indoor temperature needs to be maintained for 5
minutes after changing to another temperature, and the fan speed is
switched accordingly.
- When the indoor temperature is lower than 18
°
C, the display shows "LO".
When the indoor temperature is higher than 35
°
C, the display shows "HI",
and the specific temperature is no longer displayed.
- Press the ECO mode button on the remote control to directly enter into
ECO mode, the wind speed will change with the indoor temperature.
Press it again to exit ECO mode and restore the original state.
- In ECO mode, press the switch / wind speed key to cancel the ECO
mode and automatically switch to normal wind and adjust the wind speed.
對 流 扇
Convection fan
- ECO
模式下，室內溫度變化到另一溫度後需維持持續
5
分鐘，風扇風速才相應切換。
8.
如需關機
，按開關/風速鍵 直至停機為止。
8. To turn the Fan off, press the key until it stops.
7.
預約開機
:
在待機模式下，按下定時設置鍵 ，選定
9
個不同的預約開機時間，分別
由
1
至
9
小時，
LED
顯示屏將會顯示所選開機時間及閃動，當
LED
顯示屏閃動時，可同
時設置左右送風、送風模式、及風速等功能。
7.
PRESET START TIME: In Standby mode,
pressing the key to set desired preset power
start time, There are 9 time intervals, from 1-hour to 9-hour. The LED will be flash
on and displayed the start time setting on the LED screen. OSC, MODE and SPEED can
be set at the same time when the LED indicator flashes.