Step 7; See Figure 7:
Install ROPS Brackets (11) and Top Frame (12).
Door alignment.
A.
Place the Rops Brackets on the rops as
shown. Insert two 1/4” x 2 3/4” bolts up through
the holes. Add nuts. Do not tighten at this time.
11
B.
Place the Top Frame onto the bent ends of
the posts. Insert four bolts upwards and add
locknuts. Do not tighten at this time.
C.
Insert two 3/8” x 1” bolts up through the
holes in the Rops Bracket and the tabs on the
Top Frame. Place a 3/8” flat washer over each
bolt and add a 3/8” locknut. Do not tighten at
this time.
D.
Follow the instructions in the Door Hardware
Package to install the Door Bottoms and the
Door Latches.
Figure 7
E.
Install and latch both Doors for proper
alignment
F.
Tighten all framework bolts at this time.
G.
Place the notched plastic covers on the bent
ends of the rear posts and place the round
plastic covers on the tabs at the rear. (at white
arrows)
Step 8; See Figure 8:
Apply adhesive fastener to fender.
A.
Thoroughly clean the area where the
adhesive fastener is to be applied.
B.
Apply the fastener to the inside edge of the
fender to correspond with the fastener strip
sewn to the forward edge of the door.
C.
Remove the doors.
NOTE:
To remove doors, lift the rod out of the
bottom hinge and then lower it out of the top
hinge.
12
Inside rear edge
of right fender
Figure 8
8
