040032
-
06
-
24
-
00
040032
-
08
-
24
-
00
040032
-
08
-
15
-
00
6’
or
8’
Table Extension Kit
To assembly the
6’
or
8’
extension table kit please open box and remove
all pieces and look over the components on the previous page. Then
make sure you have a clear area to work in and use the cardboard box
to lay down as a base on the floor so as not to scratch up the top of the
table.
Step 1
Begin by lying the table section (item #1) on a flat surface (with card-
board or something down) facing down. Then assemble the support b
race (item #10) into the table assembly as shown by using the (4 sets) of
5/16 carriage bolts, washers and nuts. Place the carriage bolt in from
the outside and use the flat washer, lock washer, and hex nut on the
inside.
Step 2
Assemble the (2) extension braces (item # 3) in the same table section
you just installed the brace into and as shown in the diagram on the
right. Make sure to leave the holes on the bottom side of the brackets
facing away from the table top (they will be used in the next step) using
the (2) sets of 5/16 carriage bolts, washers, and nuts.
Step 3
(Not needed for narrow tables)
Before attaching the extension support / leveling bracket (item 2) install
(2) 5/16
-
18 x
3”
set screws with lock nuts on either side of the bracket)
into the holes as shown at right. These set screws will allow you to fine
tune the surfaces of the tables to make sure they match perfectly. As-
semble the (1) extension support / leveling bracket (item 2) by bolting
them to the 2 mounting holes on the bottom of each of the extension
braces.
Step 4
Then attach the other table section to the extension braces and repeat
the above steps finish assembly of the table.
Step 5
Attach the final support brace (item #10) to the second table section as
it was done above in step1.
Step 6
Assemble the adjustable leg as shown on pg 3 & 4. Then attach to the
table assembly as shown, note the support brace (item10) will already
be attached to the table assembly.
Extension
Braces
