7576/G4
12V AC 50Hz
Installation Diagram
IP55
Contents
1 - Screws
2 - Grill
3 - Rubber Seal
4 - Prismatic Glass
5 - Base
6 - Insulating Sleeves
Required for Installation
-
Screwdriver, flat-head
- Small screwdriver, flat-head
- Drill (if holes are required)
A
B
C
Fixing screws*
12V Transformer*
Connector*
D Main Supply*
(*not supplied)
Key
Installation and Assembly Instructions
Guarded Step Light
1
2
4
5
3
6
This fitting comes fully assembled; unscrew the two screws to remove the front grill.
The G4 version of this fitting requires a remote transformer. This shoud be a 12V AC low voltage halogen
transformer, min 10VA, installed a maximum of 3m away in a suitable enclosure. No connector blocks are supplied;
this product should be installed by a suitably qualified person.
Follow the instructions overleaf to install. Having installed fitting, insert bulb and replace front grill over glass and
rubber seal with two screws. Do not overtighten.
G4
10W MAX
Cable entry
gland
Fixing holes
A
C
D
B
NOTE: Cover internal
wiring with the sleeves
provided.
G4
CAPSULE
LAMP GUIDANCE
TYPE*
WATTAGE**
BASE
SHAPE
HALOGEN
LED
10W MAX
3W
* Warm white (2700k) low energy lamps recommended.
** Wattage value provided as a guide to suitable lamps. Lower wattage than stated may be used.
PLEASE READ THE INSTRUCTIONS ON THE REVERSE BEFORE YOU BEGIN INSTALLING YOUR LIGHT
