6
7
844·674·4461
WWW.ORIGINACOUSTICS.COM
SEASONS INSTALLATION MANUAL
If it’s difficult to insert the connector because the mounting brack-
et is in the way, the bracket can be rotated to the side. Simply turn
the knobs on the top and bottom counter clockwise to loosen the
bracket so it can be moved to the side.
Slide the cover up the wire and reattach it to the speaker.
Connect the wire to the amplifier, and make sure the wire con-
nected to the left speaker output will be routed to the left speaker,
right output to right speaker, etc.
5) Adjusting the Bass
Our season speakers are de-
signed to compensate the bass
for the effects of outdoor bass
(0dB). The OS56 and OS66
models have a switch to adjust
the bass for indoor use (-3dB).
6) Aiming the Speaker
If you haven’t already, turn the
knobs at the top and bottom
counter clockwise to loosen
the mounting bracket. Turn the
speaker so it’s facing the way
you’d like it to face and tighten
the knobs.
The knobs, bracket, and end caps can be fully removed, but for
the most part there’s no benefit in doing so.
Figure7.1: Bass Terminal
4) Connecting the Wire
Strip ¼” (6 mm) of the insulation off both ends of the wire. To
avoid stray strands, twist them at the end.
On the speaker, remove the rubber cover from the input terminal.
Pull the wire through the cover, so it can be reattached to the
speaker after the wire has been connected.
Insert the wires into the connector, making sure that the positive
wire is being attached to the (+) connection and the negative wire
is being attached to the (-) con-
nection. (If the negative and
positive wires are switched,
speaker performance will be
drastically impacted.) Insert
the connector into the match-
ing receptacle on the speaker.
Figure 6.1: Strip Wire
Figure 6.2: Twist Ends
Figure 6.4: Attaching
Wires to Plug
Figure 6.3: Input Terminal
