10
DRY GAIN Control
DRY GAIN Control
The DRY GAIN trimmer adjusts the level of the DRY signal that is mixed with
the O.D. signal using each channel’s BLEND control.
Since the pedal’s overdrive circuitry can introduce considerable additional
gain, the DRY GAIN control allows you to effectively balance the relative
levels of the DRY and O.D. signals when using the BLEND control and the
footswitchable BLEND OVERRIDE function (see FOOTSWITCH below).
Please note: the DRY GAIN control is not active when the pedal is in BYPASS
mode.
Re-amp EQ Controls
The RE-AMP EQ ensures compatibility with a wide range of amplifiers. Instead of altering your amp tone
controls to suit the RevivalDRIVE Hot Rod, set your amp for the desired clean sound then use the RE-AMP
EQ controls to adjust the RevivalDRIVE Hot Rod’s output accordingly.
RE-AMP EQ switch:
The RE-AMP EQ switch offers a choice of three different output filters.
PWR AMP:
Use this setting when plugging into a flat-response power amp. This EQ is set more or
less flat, with a subtle bass boost applied after the overdrive circuit to imitate the resonant loading of
the speaker in a guitar amp.
EQ1:
Designed to suit the response of a Blackface Fender amp, EQ1 applies a low-pass filter to roll
off excessive highs. Use this setting when plugging into a bright-voiced guitar amp.
EQ2:
Voiced for a Marshall amp with the channels bridged, EQ2 sits between the other two,
applying a high shelf cut to gently rein in high frequencies.
With the additional front-mounted filter controls on the RevivalDRIVE Hot Rod CUSTOM, the EQ2
position on the standard RevivalDRIVE Hot Rod gives way to a highly tweakable custom filter,
designed to deliver universal compatibility for most mainstream guitar amplifiers.
Custom Panel Controls: “RevivalDRIVE Hot Rod CUSTOM” below
for more information.
Summary of Contents for REVIVALDRIVE HOT ROD EDITION
Page 1: ...OWNER S MANUAL Version 1 0 ...
Page 20: ......