2. Pad and Brush Size
Use a 45cm Quick Release brush or a 45cm Quick Release pad holder with a 45cm pad.
Fitting a Brush or a pad holder
MAKE SURE MACHINE IS NOT PLUGGED IN. Bring the Handle to the upright locked position and have the
wheels in the down position (see picture 7). Standing behind the machine, lay the machine back unto the floor.
Locate the brush or pad holder to the centre of the Quick Release Adapter (see picture 8) and push on. Then
lock the Quick Release Adapter by turning the lock plate in a clockwise direction. (See Picture 9)
Return the machine to an upright position.
Note:
The Origin Suction Polisher is supplied with a bassine brush that is suitable for this machine. Other type
of brushes can effect the result on the floor and can cause increased amperage overload on the motors.
The same is true for different pads. Seek advice from your Dealer.
3.
Once machine is in the upright position lift the wheels of the floor (See Picture 10) with your foot as far
up as they will go while holding the handles. Adjust the handles to a comfortable position, usually just
below your waist. Check that the skirt is sitting evenly on the floor.
Picture 10
4. Controls and Indicator Light
At the top of the handle switch box is a light that indicates electric power to the machine when lit.
The front of the switch box has to push buttons which are a safety locking device to prevent switch levers
from accidentally activating. Under each handle grip are the switch levers that activate the switch. On the
side of the switch box is the vacuum switch.
The label on the front of the switch box indicates that the push button lock must be pushed in before lifting
the switch lever. Each button unlocks the switch lever next to it. To activate the machine either switch lever
or both together will start it. (See Pictures below).
Before switching the machine to on, make sure you have the cable laying
away from the brush area and know where the cable is at all times.
Picture 9
Picture 8
Picture 7
