8
Explorer Collection™ Manual
(Unlocked)
Bayonet Ring
Push Tabs
Against Rail
Adjust the clips so that they’re positioned at the top of the rail. If they’re not al- ready
there you can do this by pushing the release tabs (or metal “buttons”) on the inside
of the rail and pulling the clips to the top of the rails. Insert the bayonet ring into the
hole in the ceiling by gently bending the clips inward. Reach inside the bayonet ring
and push the clips down so that the bayonet ring is firmly in place, but not too tight.
If for some reason the bayonet ring needs to be removed, reach inside and push the
release tabs to fully remove the clips. After the clips have been removed, the bayonet
ring can be taken out.
4. Installing the Bayonet Ring
5. Connecting the Wire
+
-
RED
BLACK
To further maintain installation integrity,
the Explorer collection uses screw-down
Phoenix connector. Note the positive (+)
and negative (-) indicators on the connector
and make wire connections appropriately.
Ensure that the positive wire is being
attached to the positive connection and
the negative wire is being attached to
the negative connection. If the negative
and positive wires are switched, speaker
performance will be drastically impacted.
