Mains Charger:
The general procedure to adopt is use the laser during the day & charge-up
overnight. You cannot damage the system by "over-charging" the batteries.
When plugged into a 230V mains supply, the red LED flashes every 1 sec.
Connect to the rubber protected socket (located in the corner / base of the
battery pack) & this LED should be ON continuously:
ie. Red LED = charging; Green LED = sufficient charge to operate.
Even though the Green light is ON, we still recommend a full 6 hour charge.
The SP206 can be operated with the charger connected to the mains supply, if
required and site conditions permit. On receipt of your
new
laser, we suggest
charging the batteries fully for approx. 5 - 6 hours.
A Spare Rechargeable Battery is available to purchase as an optional extra &
can be used as a back-up power source.
Positioning the Laser:
Mount the SP206 on a generally level, firm surface or 5/8” threaded Tripod.
To operate correctly, this surface must be /-5 deg of true horizontal.
The laser can be used Indoors or Outdoors, where it is waterproof to IP54.
Controls:
Power ON/OFF is via the red button. The laser takes approx. 15-20 seconds to
auto level (possibly fine setting again) & then the head rotates continuously
to project a visible, red laser beam. The rotational speed is variable in four
increments. Adjust head speed using the yellow speed control button (right
hand side, lower position) & when pressed, it stops the red dot then increases
the head's rotational speed in four steps up to a maximum speed of 600rpm.
For Interior work, we suggest using slower speeds, where the laser beam is
2
