8
OpErATING ThE pArENT UNIT
5 Operating the Parent Unit
Switching the parent unit on/off
TURN ON - Press and hold this button until you hear
2 beeps. The Oricom logo appears then the image
being taken by the baby unit camera will appear.
TURN OFF - Press and hold this button for approx. 1
second to switch the unit off.
Adjustable Volume
Use this button to adjust the volume to one of five
settings. The volume levels will be adjusted on both
the baby unit and parent unit simultaneously.
NOTE: The volume cannot be turned OFF.
Setting the brightness
Press this button once.
This icon appears in the display for a few seconds.
Use these buttons to adjust the brightness to one of
five settings.
Adjusting the temperature Indicator
IMPORTANT INFORMATION
The parent unit has an in-built temperature sensor which is not
as accurate as a medical thermometer. It only measures the
temperature at the specific point it is located. The measurement
range of the sensor is 0 - 40 degrees C.
Temperature Display
Your monitor is pre-set to display the temperature
measured in Centigrade, should you wish to change it,
follow the steps below:
Press this button twice.
This icon appears in the display for a few seconds.
Use this button to set temperature indicator to OFF,
°C or °F.
The temperature that is measured by the Baby unit
is displayed on the parent unit e.g. in °C.
Turning the night light on/off
Press this button three times.
This icon appears in the display for a 15 seconds.
Use this button to turn the night light on the baby unit
on or off.
Summary of Contents for Secure 700
Page 19: ......
