4
GETTING STARTED
6 Press
[ ] to turn the Parent Unit on.
s "EFORElRSTUSEORIFITHASBEENOUTOFUSEFORALONG
time, the Parent Unit will need to be charged for 16
hours before use. After this time, the Parent Unit will
operate from the Charger pod when switched on. Note
that the Parent Unit cannot be used without a battery
pack, even if it is placed in the charger.
For the Baby Unit
1 In the event of a power failure, your Baby Monitor can
switch to battery power. It is therefore recommended that
you insert non-rechargeable batteries in the Baby Unit.
2 Remove the battery cover on the
back of the Baby Unit by pressing
and sliding it down. Inser t 3
alkaline batteries of the type AA
(not provided) as marked on the
unit and close the cover again. Do
not use rechargeable batteries in
the Baby Unit.
3 Plug the power cord into the power input at the side of
the Baby Unit and plug the adaptor plug into a mains
power socket.
4 Press
[ ] to turn on the Baby Unit.
s 4HE"ABY5NITSHOULDBEPLACEDABOUTMETRETO
metres away from the baby's cot on a flat surface.
Never place the Baby Unit inside the cot, bed or
playpen. Make sure the unit, cords and mains adaptor
are out of reach of the baby and other young children.
Never place either Unit on antique or polished
SURFACESASSLIPPAGEORSCUFlNGMAYOCCUR 4HEUNIT
may cause harm if it falls onto baby or other young
children.
Note:
If you place the Parent and Baby units too close together
you will hear a high pitched noise called "feedback", this is
normal. The units are designed to be located in separate
rooms.
To prevent feedback, do not take the parent unit into the
nursery/baby's room.
Slide