5
EN
SET UP BASE STATION
NOTE
Install batteries in the remote sensors before the
base station matching the polarities (+ and -).
1. Slide open the battery door.
2. Insert the batteries, matching the polarities (+ / -).
3. Press
RESET
after each battery change.
4. Close the battery door.
NOTE
Do not use rechargeable batteries. It is
recommended that you use alkaline batteries with this
product for longer performance.
NOTE
Batteries should not be exposed to excessive
heat such as sunshine or fire.
The battery icon indicator
may appear in the
following areas:
AREA
MEANING
Weather Forecast Area
Battery in the base station
is low.
Temperature or
Humidity Area
The displayed channel
indicates the outdoor
sensor for which battery
is low.
Wind Speed / Wind
Direction / Wind Chil
Area
Battery in the wind
sensor is low.
UVI / Barometer /
Rainfall Area
Battery in the UV / Rain
sensor is low.
CONNECT AC ADAPTER
Connect the supplied power adapter to the power jack,
then plug into a standard AC outlet.
NOTE
• The batteries are only for back-up use. Always connect
the unit to the power grid source via AC/DC adapter.
• Make sure the adapter is not obstructed and is easily
accessible to the unit.
• The base station and adapter should not be exposed
to wet conditions. No objects filled with liquid, such as
vases, should be placed on the base station and adapter.
• To completely disconnect from power, unplug adapter
from the mains.
VERIFY CONNECTION
Before proceeding to install sensors outside, please verify
communication to the base station.
WIND SENSOR
Press
SELECT
until the selected area icon is in the
middle display area.
• Wind speed: Gently rotate the wind vane and confirm
a numerical reading on the base station, e.g.,
.
• Wind direction indicator. Move the direction of the
wind indication and verify the icon moves in the same
direction
.
TEMPERATURE / HUMIDITY SENSOR
1. Press
SELECT
until the selected area icon is in
the upper display area.
2. Press
/
to select channel 1
and verify a
numerical reading.
RAIN GAUGE
1. Press
SELECT
until the selected area icon is in
the lower display area.
2. Press
MODE
until
is displayed.
3. Tilt the tipping funnel on the rain gauge several times
and verify a numerical reading on the base station.
