Oregon Scientific WMR86N, User Manual, Page: 6 / 100

4
EN
RAIN gAUgE
Base and funnel:
1. Rain gauge
2. Battery compartment
3.
RESEt button
C
1. Funnel
2. Indicator
oUtdooR tEMPERAtURE / HUMIdItY
SENSoR
1. LED status indicator
2.
RESEt hole
3. °c / °F: Select temperature unit
4. cHANNEL switch
5. Battery compartment
gEttINg StARtEd
NotE Install batteries in the remote sensors before the
base station matching the polarities (+ and -).
NotE Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.
SEt UP REMotE WINd SENSoR
The wind sensor takes wind speed and direction
readings.
The sensor is battery operated. It is capable of
transmitting data to the base station wirelessly within an
approximate operating range of 100 meters (328 feet).
to insert batteries:
1
2
1. Unscrew the anemometer from the wind sensor
carefully.
2. Insert batteries matching the polarities (+ / -) and
replace the anemometer. Press RESEt after each
battery change.
SEt UP REMotE tEMPERAtURE / HUMIdItY
SENSoR
The remote sensor can collect data from up to 3 channels.
to set up the remote sensor:
1. Slide open the battery door.
2. Slide channel switch to select a channel (1, 2,
3). Ensure you use a different channel for each
sensor.
3. Insert the batteries, matching the polarities (+ / -).
4. Press
RESEt after each battery change.
5. Close the battery door.
SEt UP RAIN gAUgE
The rain gauge collects rain and takes rainfall readings.
The sensor can remotely transmit data to the base
station.
to set up the rain gauge:
1. Remove screws and slide the cover off in an upwards
motion.
2. Insert the batteries (2 x
UM-3 / AA), matching
the polarities (+ / -).
Press RESEt after each
battery change.
3. Remove the fibre tape.
1
5
2
3
4
C F
P/N:300102839-00007-10 REV1.0 Page: 6 /100