STEP 7:
Loosely attach the latch assembly (1) to the bottom side of the beam as shown in the diagram using the
two 1/2” x 1-1/4” GR 5 hex cap bolts (4), the two 1/2” lock washers (3) and the two 1/2” hex nuts (2). Lower
the beam onto the tongue. Center the latch assembly on the tongue and tighten hardware.
Page 9
1
Beam Lock
1
2
1/2” Hex Nut
2
3
1/2” Lock Washer
2
4
1/2” x 1-1/4” GR5 Hex Cap Bolt
2
5 Beam
Assembly
1
ITEM NO.
DESCRIPTION
QTY.
Area of
Detail
ITEM NO.
DESCRPTION
QTY.
1
1/2” X 38” Pressure Hose
1
2
3/4” x 56” Return Hose
1
3
Worm Gear Clamp
3
STEP 5:
Connect the end of the 1/2” ID x 38” hydraulic pressure hose (1) coming from the fitting on the pump to the
fitting on the valve. See illustrations below.
STEP 6:
Slide one hose clamp on the end of the 1/2” x 56” hydraulic return hose (2 ) that comes from the fitting on the
filter. Then connect the hose to the fitting on the valve.Tighten hose clamps. See illustrations below.
