GB
5
To start the timer:
-
Press [ST / SP]. The timer will start.
Note:
- When the timer reaches 0:00:00 a beeping alarm will
activate to indicate that the timer has completed its
cycle. The alarm will last for one (1) minute. After
one minute, the alarm will continue to make one
short beeping sound once every two-minutes. To
stop the alarm, press any button and the timer will
utomatically reset to the original timer setting.
- When the timer is active, the timer icon will appear
and be flashing on the pulse-mode display and the
clock display.
To stop the timer:
-
Press [ST / SP]. The timer will pause until [ST / SP] is
pressed again.
To clear the timer:
1. Press and hold [MODE] for 2-seconds. The digits will
return to zero and the hour digits will flash.
2. Without entering a number for the hours, press [MODE]
again. The Minute digits will flash.
3. Press [MODE] a final time to exit the timer-setting
mode.
The timer is now cleared.
To reset the timer to its originally set time:
-
Press and hold [ST / SP] for 2-seconds. The display
will return to its originally set time.
MAINTENANCE
1. Do not immerse the unit in water. If the unit comes in
contact with water, dry it immediately with a soft
lintfree cloth.
2. Do not clean the unit with abrasive or corrosive
materials. Abrasive cleaning agents may scratch the
plastic parts and corrode the electronic circuit.
3. Do not subject the unit to excessive: force, shock,
dust, temperature, or humidity. Such treatment may
result in malfunction, a shorter electronic life span,
damaged batteries, or distorted parts.
4. Do not tamper with the unit’s internal components.
Doing so will terminate the unit’s warranty and may
cause damage. The unit contains no user-serviceable
parts.
5. Only use new batteries as specified in this instruction
manual.
6. Read this instruction manual thoroughly before
operating the unit.
