7
GB
ALARM AND SNOOZE FUNCTION
When the daily alarm goes off, the backlight will be on for five
seconds and the ALARM ON
icon will flash.
The alarm is a crescendo alarm with 3 stage increase in intensity
.
Without interruption, the unit will
sound
for two minutes.
To stop the alarm, press
the [ALARM] button
. However, if the [
] bar is pressed, the SNOOZE function will be
triggered.
Though
the alarm will stop the ALARM ON icon
will
blink
for eight minutes. After that the alarm will go off again.
To deactivate the SNOOZE function, press the [
ALARM
ALARM
ALARM
ALARM
ALARM
] button.
CHECKING INDOOR AND REMOTE
TEMPERATURES & HUMIDITIES
To display the indoor and outdoor temperature and humidity
readings, press the
[
CHANNEL
]
button to toggle among the indoor,
Channel 1, 2 and 3 displays.
The temperature can be shown in Centigrade (°C) or Fahrenheit
(°F). Select the appropriate reading by using the °C/°F slide switch
(located in the battery compartment). Slide the switch to °C for
Centigrade or °F for Fahrenheit.
This unit has an auto-scan function that can sequentially display
the indoor and remote readings.
To activate this function, press and hold the
[
CHANNEL
]
button
for 3 seconds. To deactivate press the
[
CHANNEL
]
button again.
If the reading goes above or below the
specific measuring range
, the
display will show a flashing “HHH” or “LLL”.
NOTE ON REMOTE READINGS
Once batteries are in place in the remote unit, it will start
transmitting samplings at 40 second intervals.
If no signals are received when the remote sensor display is selected,
“
” will be displayed.
To search for remote sensor signals,
press together the [MEMORY] and [CHANNEL] buttons on the
main unit.
If the unit still displays "- - -" re-insert the batteries or remove the
back panel of the remote unit and press reset."
If that fails, check that the remote sensor is still in place. Make sure
the transmission is within range and the path is clear of obstacles
and interference.
Repeat this procedure whenever you find discrepancies between
the display on the main unit and the display on the remote sensor.
NOTE ON °C AND °F
The outdoor temperature display on the main unit is dominated by
the selection on the °C/°F slide switch of the main unit. Whatever
the display unit of the remote sensor is, it will only apply to the
remote sensor itself and the temperature will be automatically
converted to the chosen one of the main unit.
MAXIMUM AND MINIMUM
TEMPERATURES & HUMIDITIES
The maximum and minimum recorded temperatures and humidities
will be automatically stored in memory. To display them, press
