E
N
G
L
I
S
H
9
Fan Housing Blockage:
If blockage occurs at the bottom of the air flow system follow the steps below:
4.
Lift the entire outer bag and the intake
tube assembly up and out of the fan
housing opening.
5.
Remove blockage at the opening of the
fan housing.
high
low
Fan housing opening
4
5
1.
Unzip the outer bag and remove the
disposable inner bag from the bag dock.
2.
At the very bottom of the outer bag you
will find an intake collar. Twist the
intake collar counterclockwise to unlock.
3.
Lift the collar up the intake tube.
high
low
TWIST TO LO
CK
Intake collar
1
3
2
Motor Protection/Vacuum Shutdown
If the vacuum becomes overloaded, which could occur by sucking up a large obstruction or on
extremely thick carpet, the electronics is designed to shut down the vacuum. If this happens, the
vacuum will be turned off but the headlights will remain on. To reset the vacuum turn the unit
off, wait 5 seconds, and then turn it back on. If it shuts down again there may be a large
obstruction in the vacuum. See page 8 for the steps on clearing a blockage.
NOTE:
If the above actions do not correct the problem, contact an Oreck authorized
service center or call the customer service center.
US:
1-800-551-6299
Canada:
1-888-676-7325
