4
E
N
G
L
I
S
H
Assembling the Handle Tube
Up-Position Lock -
Place foot on power head and lean handle back gently to release lock for vacuum use.
Return handle to the full upright position to engage lock.
Note:
Do not operate the unit while in the upright and
locked position. Do not let the unit run while in any one stationary position for any period of time.
Keep the unit moving while in operation.
Easy Power Cord Storage -
Wrap power cord around cord hook on handle and cord hook on connector. Secure
to “U” shaped part on plug.
Before assembling appliance, remove two screws from the connector assembly. Remove insert by pulling
upward.
Slide upper handle section over the matching section of the connector assembly. Insert short screw into
top hole and long screw into the bottom hole then tighten firmly until handle is no longer loose.
Snap cord assembly into the cord clip located on the left side of the collar. Leave excess cord at the power head
to allow movement.
Operating the Vacuum
Make sure the HEPA Filtration Odor Fighting Bag is in place.
DO NOT
operate the cleaner without a dust bag.
Plug the power cord into an electrical outlet and press the
On (
l
) - OFF (
O
)
switch on handle assembly when
ready to operate.
1
2
3
4
5
3
1
2
Connector
Assembly
Upper
Handle
5
Operation
4
WARNING: Unplug cord from electrical outlet before servicing.
BAG REMOVAL:
Unzip outer bag completely.
Pull bag cardboard collar to release bag dock door from connector. Bag dock door will hinge downward.
Gently pull bag cardboard collar upward out of the bag dock. Saniseal
®
dust seal will close automatically.
BAG INSTALLATION:
Slide the cardboard collar completely onto bag dock door.
Firmly push bag dock door with both thumbs on indication point until it snaps.
Replacing the HEPA Filtration Odor Fighting Bag
6
7
8
9
10
6
7
8
9
10