Orbit 57894, User Manual

Page: 6 / 76

6
1. Select a Location
When choosing a location for your timer, consider the
following:
• Choose location near a power source (if hard wiring) or
electrical outlet (applicable only to U .s . retail timers)
• ensure operating temperatures are not below 32° or
above 158° Fahrenheit (below 0° Celsius or above 70°
Celsius)
• Place it away from direct sunlight if possible
• ensure at least 9” of space to the left of the sprinkler
timer box for the door to swing open after installation
• locate the timer where there is easy access to sprinkler
wire (from valves) . if mounted in an outdoor location,
shut the compartment door to keep the timer safe
from weather damage . To lock: insert the key and turn
clockwise to the locked position
Note: Sprinkler timers are weather-resistant to UL-50 and ETL
®
Listings, but should not be placed in areas where continuous
water could cause damage.
2. Mount the Timer
• Use the mounting template (included) to mark the
mounting screw location on the wall . See figure 1
• install a No . 8 screw (included) into wall in the upper
template location . leave the screw head protruding 1/8”
(3mm) from wall . Use expanding anchors (included) in
plaster or masonry, if necessary, for a secure hold
• slip the timer over protruding screw (using keyhole slot
in back of timer) . See figure 2
• drive a No . 8 screw through one of the two pre-formed
holes located in lower back cabinet . See figure 2
Figure 2: Hang timer on screw using keyhole
Keyhole
Pre-formed
mounting holes
No. 8 Screw
Wall
1/8"
MOUNTING TEMPLATE
GABARIT D`INSTALLATION
GUIA DE COLGAR
4.17”
(106 mm)
p 801 295 9820
f 801 951 5815
www.fl uid-studio.net
1065 South 500 West
Bountiful, Utah 84010
proof no:
3
date: 10.05.07
des: SM spck: SM
job no: 07WTM005259
client: Orbit
sku: 57880
upc: ? ????? ????? ?
fi le name: 07WTM005259
57880-04 rA.indd
software: Illustrator CS2
colors
additional instructions:
·
·
crop color
non printing
PMS
????
PMS
????
color
non printing
PMS
????
Registration
K
Printers are responsible for
meeting print production
requirements. Any changes
must be approved by the
client and Fluid Studio.
printed piece must meet
designated specifi cations
on this form.
dimensions:
fl at: w: 9" h: 7"
fi nished: w 9" d: 0" h 7"
© 2007 Fluid Studio. This
work is the property of Fluid
Studio, and cannot be used,
reproduced or distributed
in any way without their
express permission.
Figure 1: Use Mounting Template (included)