Orbit Controls OC 7040A, Owner'S Manual

Page: 7 / 14

3 TERMINALS
RS232 Request Transmission
RS232
Continuous Transmission
4 MENU
The key
MENU opens the Menu. The required parameter will be confirmed with ACK . .
With UP or DOWN the parameters will be set.
The flashing digit - Cursor - can be positioned with ACK . The sign and the decimal point can be set after
the cursor is positioned outside the display range (none of the digit is flashing).
The key
UP sets the decimal point, the key DOWN sets the sign. The key SET terminates the
programming and the display returns to the measuring mode.
KEY DISPLAY
FUNCTION
MENU PASS
Password selection from 20 stored combinations
ACK P 0200 Select with UP or DOWN
MENU OrdEr Decimal Point, Display Resolution
ACK CCCC.dd Select with UP or DOWN
MENU Fn tArA Tara function OFF, ONLY or ON.
ACK ONLY After pressing the key SET the display will be forced to zero
ON The key SET pressed once forces the display to zero. When pressed for
second time, the display returns to the non-tare original signal value.
MENU FiltEr Setting of filter constant (averaging filter type)
ACK OFF Selection: OFF and 1, 2….99
MENU Count Counting of the last digit:
ACK 0 Dummy Zero
1 The display increments 1, 2, 3….9, 0
2 The display increments 2, 4, 6…
5 The display increments 0,5,0,5…
MENU dSP Display refresh after selected number of measurements
ACK 1 Selection: 1, 2….50
MENU SP 1 Set Point SP1
ACK XXXXXX Selection: -999999 to 999999. The relay is activated when the display
arrives at the SP1 or higher values
MENU HSt 1 SP1 Hysterese
7