Orbit Controls OC 3010, Owner'S Manual

Page: 13 / 26

13
Decelerometer and external force sensor:
Decelerometer and external pressure sensor:
When the Decelerometer is switched ON and OFF more time per day, the key MENU can
be pressed to cancel the control procedure after the display shows:
2.2 Configuration
By pressing the appropriate keys in the mode measuremen t, the measurement, the
calibration or the printing can be started, or the previous measurement can be displayed.
By pressing
MENU the menu mode is initiated - see § 2.4.
2.3
Calibration, Measurements and Printing.
2.3.1 Calibration
In the measuring mode the instrument measures, calibrates or prints the data. Any of
these activities may be selected by depressing one of the keys MEAS, CAL or PRN . After
pressing CAL the offsets of the deceleration sensor, the force sensor or the pressure
sensor are set for zero reference values.
At the end of the calibration the display shows:
Measure N. 1
9.8 m/s
2
500N
Measure N. 1
9.8 m/s
2
300kPa
Calibration
Offset
End of
Calibration
Brake tester ***
***Decelerometer