The sensor head can tilt about one of its axes if it is desired to displace the detection
area.
DETECTION INDICATORS
There is a red LED inside the sensors that lights when a detection is made. This
LED can be used to assist in the adjustment of the detection field without needing to
connect the load.
SETTING THE BRIGHTNESS (only in master sensor)
The DI circuit, as well as circuit 1 of the DICROMAT 2+, can be
graduated to react only when the light conditions are below the level selected. By
rotating the brightness selector to the position “
☼
” they will react under any condition
of brightness. By rotating the brightness selector to the position “
e
”
they only react in
low brightness conditions. Circuit 2 (T1-T2) of the DICROMAT 2+ always reacts
independently of the regulated brightness.
For the changes made to take effect in the potentiometers in the adjustment of
the equipment, it is necessary to get out from the detection area and wait for
the installation to be turned off.
SETTING THE DISCONNECTION DELAY (only in master sensor)
By rotating the "Time 1" and "Time 2" selectors, the disconnection delay of the
circuits is adjusted.
TECHNICAL CHARACTERISTICS
Power supply:
230 V~ 50 Hz
Breaking power:
μ
10 A 230 V~ Cos
φ
= 1
Recommended peak loads:
Incandescent lamps
2200 W
Fluorescent tubes
400 VA
Low voltage halogens (12V)
2000 VA
Halogens (230V)
2200 W
Low consumption lamps (CFL)
400 VA
Low consumption lamps (Downligts)
400 VA
LED lamps
400 VA
Own consumption:
DI: 7 VA capacitive (1.1 W approx.)
DICROMAT 2+: 4.2 VA capacitive (3.1 W
approx.)
Brightness range:
2 – 2000 LUX
Timing range:
DI (L
): From 1 s to 10 min.
DICROMAT 2+:
-TIME circuit 1 (L
): From 1 s to 10 min.
-TIME circuit 2 (T1-T2): From 10 s to 15 min.
Detection angle:
360°
Detection field:
Up to 7 m in diameter at 2.5 m high
Operating temperature:
-10° C to +45° C
Type of protection:
IP20 as per EN 60529
Protection class:
II in correct assembly conditions
DIMENSIONS
SENSOR WIRING DIAGRAM
01_2012 / A016.13.54011
ORBIS TECNOLOGÍA ELÉCTRICA, S.A.
Lérida, 61 E–28020 MADRID
Teléfono:+ 34 91 5672277; Fax:+34 91 5714006
E-mail: info@ orbis.es
http://www.orbis.es
