Orbea BLUE PAPER ALMA CARBON OMX 2021, Technical Manual, Page: 22 / 68

TECHNICAL MANUAL BLUE PAPER ORDU · OMX 2021 42 | ORBEA ORBEA | 43
EN
The incorrect installation of the bicycle com-
ponents may be the cause of accidents and
serious injuries, or even death.
Damage to the bicycle and/or components
due to incorrect installation are not covered
by the warranty terms.
Read the assembly and spares sections of
this manual for the correct torque settings
and assembly compounds to be used on all
components.
09
ADJUSTMENT OF FITTING
ELEMENTS
Ordu OMX allows for the adjustment of several compo-
nents to achieve your perfect position on the bicycle. The
adjustment method of these elements is described in
this section.
Some of the adjustment method described
in this section requires the removal and as-
sembly of several main components of the
bicycle, as well as the removal and re-routing
of the gear cables and brake hoses, and may
therefore be beyond the mechanical skills of
most users. Orbea always recommends to
take your bicycle to an authorized dealer for
the installation, adjustment and maintenance
of your bicycle and its components.
To adjust the position of the extensions onto the bridge,
follow the method below:
1. Use a 3mm Allen jey to loosen the bridge extensions
clamps.
2. Move the extension back or forwards to the desired
position.
3. Tighten the bridge extensions clamps to the recom-
mended torque settings.
If the extensions move inside the bridge
after applying the recommended torque
settings, apply a small amount of carbon
assembly compound onto the surface of
the extensions being clamped and re-install the
extensions.
Allen 3 mm.
3
4 N.m
1
3
2 4
5
FIBER CARBON GRIP
3
4 N.m
3 1
2
EXTENSIONS POSITION
ADJUSTMENT
Ordu allows to adjust the front post height within a range
of 90mm in sizes XS and S/M and 140mm in sized M/L
and XL. To adjust the front post and extensions height,
follow the method below:
1. Use an Allen key on the hole on the bottom of the
handlebar front cover as a lever to unclip it from
the base handlebar.
2. Use an 3mm Allen key to loosen the front post clamp.
3. Adjust the front post height to the desired position.
Observe the 40mm front post minimum insertion.
4. Tighten the front post clamp bolts following the recom-
mended torque settings.
If the front post slips after aplying the recom-
mended torque setting, apply a small amount
of carbon assembly paste on the front post
and tighten the clamp back.
5. Install the front cover.
FIBER CARBON GRIP
FRONT POST HEIGHT ADJUSTMENT