ST 9100 - INSTALLATION GUIDE
1 INSTALLATION
The following section contains recommended installation guidelines for the Solution Provider (SP). These
recommendations should be incorporated into installation guidelines for end users.
CAUTION: The installer is responsible for following all safety guidelines during product installation. Refer to
the
section for details.
The terminal uses very low power during transmission and therefore presents no radiation hazard during normal use,
installation, testing, and troubleshooting.
1.1 Getting Started
Getting the ST 9100 ready for operation requires doing the following:
1. Prepare for the installation (Section
2. Determine a suitable mounting location (Section
)
3. Mount the antennas (Section
)
4. Route the main cable (Section
)
5. Connect the cables and mount the ST 9100 (Section
)
6. Connect to power (Section
7. (optional) Attach the terminal shroud (Section
8. Register the terminal (Section
1.2 Prepare for the Installation
Check that you have the items and tools listed below before installing the terminal.
1.2.1 Shipping Box Contents
Unpack the contents of the shipping boxes, and then use the list below as a guide to check that you received the
items you ordered.
l
ST 9100 (p/n ST9100-D01 for use in the Americas, and ST9100-C01 for use outside of the Americas)
l
Power and I/O connector (p/n ST101096) or blunt cut cable assembly (p/n ST101062-002)
l
Cellular antenna with FAKRA connector (p/n ST101066-001)
l
Satellite antenna with FAKRA connector (p/n ST901065-AFA standard antenna, ST901066-AFA low elevation
antenna)
l
Terminal shroud (optional - p/n ST101014-001)
1.2.2 Additional Materials
You might require some of the following materials to install a transceiver. These materials do not ship with the
terminal:
l
SIM card (Refer to section
for SIM card procurement and installation)
l
Cable ties as a mounting option for the transceiver
If fastening the transceiver unit and the antenna to a mounting surface, you require:
T414, Version 0.04 BETA
© ORBCOMM
®
Proprietary
9
