ST 9100 - INSTALLATION GUIDE
l
Do not run the cable over sharp or jagged edges.
l
Place the cable in recesses and channels, whenever possible, to prevent potential damage or wear by foot
traffic.
Note:
Remember to leave enough cable slack near the transceiver for strain relief so as not to introduce any
additional force on the connector. ORBCOMM recommends securing the cables during installation.
Figure 11: Sample Cable Placement in a Vehicle Cab
1.5.1 Protect the Cables and Cable Connectors
CAUTION: Cable management and connector strain relief must be incorporated in the installation.
ORBCOMM highly recommends securing the cable at regular intervals along its length as part of
the installation to prevent cable wear and eliminate strain on the connector. Damage to the
connector interface or cable may otherwise result and lead to hardware failure.
To protect the transceiver's connector interface, follow the guidelines below
l
Apply tape around the cable ends to help in routing the cable.
l
Secure the cable such that it does not pull on the connector or strain the transceiver connector.
l
Tie the cable down so that the weight of a vibrating cable does not stress or strain the connection.
l
Tie the cable down using cable ties and tie holders (
) at 30 to 60 cm (12 to 24 in.) intervals along the
cable route to prevent chafing, wear, or strain.
l
Secure the cable tie holder with a self-tapping screw (
) for best holder retention.
T414, Version 0.04 BETA
© ORBCOMM
®
Proprietary
20
