Orban OPTIMOD-FM 8500S, Operating Manual

Page: 160 / 335

2-104
INSTALLATION ORBAN MODEL
COMMAND PARAMETER INFORMATION EXAMPLE
TIMEOUT=
RDS terminal
connection time-
out Timeout (in minutes) between last
transmitted command and when
the Optimod disconnects auto-
matically. Use it to allow the Opti-
mod to reconnect automatically if
the terminal connection is lost
temporarily.
This command only
affects the current connection;
you must reissue it each time you
connect.
TIMEOUT=15
↵
(current connection
stays up for 15 min-
utes)
TIMEOUT=0
↵
(no auto-disconnect
occurs)
QUERIES
[HDR]?
↵
Any header and ‘?’ returns the status of the encoder memory
for that specific parameter.
PS?
↵
?
↵
Returns all settings in encoder memory.
?
↵
VER
↵ Returns the software revision number.
VER
↵
SAVE
↵
Save RDS settings to RDS System I/O.
NOTE: Any changes will not appear in the PC application if it
is open. You must reconnect to see the saved values.
SAVE
↵
INIT
↵ Use RDS parameters from System.
INIT
↵
TI
↵
Returns the current time. TIME=20:15:36
DATE=Jan. 1,
2015
RESPONSES
(Return Echo)
The command received was properly formatted and was re-
ceived and executed by the encoder. TATIME=30
Invalid Data
Entered
Incoming data is not properly formatted and hence was not
accepted and executed by the encoder. Invalid Data En-
tered
(none) Data that has been sent either has not reached the encoder
or the encoder has no response for that command. (none)
Table 2-2: Preset/Terminal RDS controls and defaults
Alternative Frequency Channel Numbers
MHz CHAN MHz CHAN MHz CHAN MHz CHAN
87.6 1 92.7 52 97.8 103 102.9 154
87.7 2 92.8 53 97.9 104 103.0 155
87.8 3 93.9 54 98.0 105 103.1 156
87.9 4 93.0 55 98.1 106 103.2 157
88.0 5 93.1 56 98.2 107 103.3 158
88.1 6 93.2 57 98.3 108 103.4 159
88.2 7 93.3 58 98.4 109 103.5 160
88.3 8 93.4 59 98.5 110 103.6 161
88.4 9 93.5 60 98.6 111 103.7 162
88.5 10 93.6 61 98.7 112 103.8 163