17
EN
Problem solving
Error messages on the display
Error code
E0
The cooker does not heat up and a beep sounds.
Make sure you use suitable dishes and that the container is in the middle
of the plate. There is no pan on the stove. Place a container on the stove.
E1
The voltage is lower than 86 V.
Check the power supply, then switch on the cooker again.
E2
The voltage is higher than 280 V.
Check the power supply, then switch on the cooker again.
E3
Plate temperature sensor not working.
Contact the nearest authorized service center.
E4
IGBT (Inner) sensor not working.
Contact the nearest authorized service center.
E5
Plate temperature is too high.
Reduce the set temperature
E6
IGBT (Inner) temperature is too high.
Check that the suction and discharge openings of the fan are blocked by
something or that the fan is working. If the holes are blocked, remove the
obstacle.If the fan does not work, contact the nearest authorized service
center.
Equipment cleaning and maintenance
Unplug the power cord and allow the machine to cool completely.
Cleaning the surface of the device
Never immerse the device in water or any other liquid!
Use only a slightly damp cloth in a mild detergent solution to clean the
surface of the device. Do not use any solvents or harsh cleaners. They can
damage the surface finish.
Routine cleaning
Wipe the appliance with a damp cloth and dishwashing detergent. Use
a vacuum cleaner to remove dirt from the fan air intake grille. Clean
the ceramic surface and the control panel with a damp cloth and mild
detergents designed for cleaning ceramic surfaces. Make sure that
no water flows into the device (if water enters the device, it may be
destroyed).
