14
EN
OPERATION
1
Plug the power cord into an electrical outlet.
2 The device enters standby mode by plugging it into an electrical outlet. The
LED indicator will turn white.
Switch on the device by pressing the button (
3
). The LED indicator will turn
white.
Briefly touch the button (
2
) to switch the mirror light on/off. The steam starts to
be released after about 16 seconds. You can then simply switch off the device
by pressing the button (
3
) again.
When steam starts to escape from the nozzle (
8
), it is normal for hot drops of
water to flow out at the beginning.
3 Steam skin care
• Keep your face at least 20 cm away from the nozzle (8).
To ensure that the steam covers your entire face, direct the current to the
upper part of the chin.
• The steam is fully released approx. 35 seconds after the appliance is switched
on.
• When the water level in the tank drops, it is normal for the volume of steam to
decrease accordingly.
The appliance switches off automatically when there is not enough water in the
water tank.
Do not remove the water tank immediately after the water has run out. This can
cause burns and scalding.
Wait at least 10 minutes for the tank to cool before removing it.
Warning!
If the appliance switches off automatically due to lack of water, the temperature
control system will be deactivated.
It is necessary to wait about 2 minutes for the main unit to cool down. The
temperature control system is then reset and normal operation is restored.
20 cm
