11
EN
Assembly and use of equipment
Follow these steps to set up and use your device.
1.
Place the body of the device (
D
) on a dry, level and fi rm surface. Do not
plug the power cord into an electrical outlet before assembling the device
completely!
2.
Slide the bowl (
B
) onto the device body (
D
) and then place the bowl cover
(
A
) on the bowl.
3.
Fit the rotary head (
C
). Make sure that you
push the rotary head fi rmly downwards with
the groove and fi t it correctly. Improper seating
of the extraction head can cause cotton candy
production failure or excessive vibration.
4.
Plug the power cord into an electrical outlet.
5.
The READY indicator lights up.
6.
Pour one scoop of pure granulated sugar into the center of the extraction
head so that it is spread evenly (you can also use a fl at tablespoon).
Notes
Do not give more than one scoop of sugar. Excessive sugar causes noise
or vibration.
Use only pure granulated sugar in this cotton candy machine.
The use of other sugar can cause cotton candy production to fail. Do not
use sugar mixed with other materials, such as coffee or powdered milk.
They will cause the extraction head to block.
Never use materials other than pure granulated sugar (eg salt).
7. Set switch 0/1 (
E
) to „on position - 1“ - the START-UP light comes on.
The head rotates and is heated by the heating unit.
8.
Cotton candy starts to form in about 2 or 3 minutes.
Wrap the cotton candy on a wooden stick as
follows:
Hold the wooden stick in an upright position, turn it
a few times from the inside around the bowl. Then
place the wooden stick horizontally and rotate it
over the rotating head and the inner edge of the
bowl to wind the cotton candy.
9.
When the cotton candy is ready, switch off the appliance by moving the
switch 0/1 (
E
) to the „off position - 0“.
10.
To make another cotton candy, repeat the procedure in the same
sequence.
