21
EN
Mounting the C-clips for the hot blowing air hose to the unit
fig. 3
fig. 4
1
Pull the C buckle for the hot blown air hose from the plastic.
2
Rotate the rotary hole at the end of the buckle onto the rotary shaft on the
rear cover and slide the clip on the shaft so that it clicks into the appropriate
direction as shown in Figure 3.
Note:
When properly attached to the rotary shaft, the C buckle will be able
to snap on the hose of the hot blow air.
3
Turn the C buckle into the snap-in position as shown in Figure 4.
Note:
Do not rotate the C buckle until it is properly installed on the shaft, as
it could damage both the rear cover rotary shaft and the C-clips.
The buckle can be attached to the device at the factory.
Installing the hot air hose assembly on unit
1
Slightly tighten the end of the hot blow air hose with the neck.
2
Grasp the end C of the buckle with your left hand and open the buckle
completely. Clutch on
Hold the other end of the hose with your right hand. Slide the end of the
hose with the neck from the top into the blow-out opening of the air duct on
the rear cover so that the throat is inserted into the semicircular protrusion
inside the opening. Once properly attached, push the C buckle with your left
hand so that the C buckle tapes the hose of the hose in the rear hood (see
figure 5).
Note:
The end of the hose must be correctly inserted into the semicircle at
the bottom of the air inlet port (see Figure 6). C the buckle must snap firmly
and secure the hose in the rear cover
guide groove
on the back cover
rotating
shaft
C clip lock
rotating
opening
