2
Front Panel
Rear Panel
1. Power/Standby Switch
Up position - amplifier is off
Middle position - amplifier is on standby
Down position - amplifier is on
2. Channel Switch
Switches between the Natural and Dirty channels
3. Power Indicator Lamp
4. Dirty Volume Control
Controls output volume level for the Dirty channel
5. Dirty Hi Control
Controls treble frequency levels for the Dirty channel
6. Dirty Mid Control
Controls middle frequency levels for the Dirty channel
7. Dirty Low Control
Controls bass frequency levels for the Dirty channel
8. Dirty Gain Control
Overdrive/Distortion level for the Dirty channel
The Gain works from left to right increasing in saturation as the control is turned clockwise.
9. Natural Volume Control
Controls output volume for this channel. Please note this channel has no gain control and
no EQ section. It is a ‘non-master volume’ channel.
9 8 7 6 5
4 3 2 1
1. Channel Footswitch Socket
Attaching an optional footswitch to this socket will allow you to remotely change channels.
2. Speaker Outputs
When using a single Orange 16 ohm speaker cabinet, (i.e. PPC412 or PPC212), attach it to the
16 ohm output socket on your amplifier.
When using two Orange 16 ohm speaker cabinets attach each one to a separate 8 ohm
output socket on your amplifier.
When using a single 8 ohm cabinet attach it to either one of the two 8 ohm output
sockets on your amplifier.
WARNING: Never use two 8 ohm cabinets at the same time.
When using the Rocker 30 combo with a 16 ohm extension speaker, disconnect the internal speaker
from the 16 ohm socket and reconnect to one of the two 8 ohm sockets. Connect the extension
speaker to the other 8 ohm socket.
WARNING: Orange Rocker amplifiers should not be used with 4 ohm speakers.
3. HT Fuse
The high tension fuse, protects transformers and other circuitry from blowing in the event
of an output valve shorting. Please refer to the Technical Specification section for fuse ratings.
4. Mains Inlet Socket & Fuse Holder Tray
This is where your mains lead plugs in. Also the mains fuse is located here. Please refer to
the Technical Specification section for fuse ratings.
5. Mains Voltage Switch
Switches amp between 220V and 240V or 100V and 120V. This should be set to the mains
electricity voltage used in the country where the amplifier is to be operated.
Please ensure your amplifier is switched to the correct voltage for your country. If unsure please consult your dealer.
5 4 3
2
2 2
1
