The New Generation of Oral Irrigators
INSTRUCTIONS FOR USE
INSTRUCTIONS FOR CLEANING
SPECIAL TIPS
IMPORTANT SAFEGUARDS
FOR SERVICE, CONTACT:
Oral Care Technologies, Inc. ATTEN: SERVICE DEPARTMENT
3030 Dublin Circle, Bessemer, AL 35022
call us: (800) 635-3594 toll-free
visit our website: www.oralcaretech.com
Continued . . .
SPECIAL TIPS FOR USE
(3) Do not twist the entire handle of your Hydro Floss
®
to achieve the
correct irrigating angle. Instead, twist the jet tip itself. The handle design
allows the jet tip to be twisted while the irrigator is operating. Twisting the
handle will ultimately cause the hose to uncoil and/or kink.
(4) Be sure to press the reservoir down firmly when returning it to its place on
the base of the Hydro Floss
®
. You may use a cup to fill the reservoir. This is
easier and less messy.
(5) The Hydro Floss
®
may take five to ten seconds to begin pumping upon
initial use. This is normal.
(6) Always leave the reservoir lid on while not in use.
(7) You may add two or three capfuls of your favorite mouth rinse to the
water in the reservoir.
(8) DO NOT add soda, salt or any other abrasive substance to the water in
the reservoir as doing so will damage your Hydro Floss®, and void the
warranty .
CLEANING
Daily
(1) Always unplug your Hydro Floss
®
before cleaning.
(2) Remove the reservoir and wipe dry both the inside and outside surfaces.
(3) Wipe dry the base and handle of the Hydro Floss
®
.
(4) Be sure to wipe dry the bathroom surfaces under and around the Hydro
Floss
®
.
Weekly
(1) Always unplug your Hydro Floss
®
before cleaning.
(2) Fill the reservoir with very warm water.
(3) Turn the pressure control knob to the “High” setting.
(4) Remove jet tip and place handle in the bottom of the sink.
(5) Firmly turn the on/off knob to the “On” position and let reservoir empty
into the sink.
(6) Repeat steps two to five.
(7) Be sure to dry your Hydro Floss
®
as described in the steps for Daily
Cleaning.
Note:
A mild cleanser
may be used on the surfaces of the base, the reservoir
and the jet tips. Never immerse base or handle in water.
