Oracle Sun Server X4-4, Installation Manual

Page: 54 / 148

Oracle ILOM Hardware and Interfaces
See Also
■
For information on configuring Oracle ILOM through Oracle System Assistant, see “Setting
Up Software and Firmware Using Oracle System Assistant” on page 71
■
For complete instructions on using Oracle ILOM, refer to the documentation for your
supported version of Oracle ILOM (supported versions are listed in the Sun Server X4-4
Product Notes ):
http://www.oracle.com/goto/ILOM/docs
Oracle ILOM Hardware and Interfaces
The following table lists the components and functions of Oracle ILOM.
Component Function
Hardware ■ Embedded service processor (SP) chipset that monitors the status and configuration
of components such as fans, storage drives, and power supplies.
■ Two rear panel external connections: NET MGT port (Ethernet connection) and
SER MGT (RJ-45 serial connection).
Interfaces ■ Web browser interface
■ SSH command-line interface (CLI)
■ IPMI v2.0 CLI
■ SNMP v3 interface
Oracle ILOM Network Defaults
The Sun Server X4-4 supports dual-stack IPv4 and IPv6 settings, which enable Oracle ILOM to
fully operate in an IPv4 and IPv6 network environment.
■
For IPv4 configurations,
DHCP is enabled by default, allowing a DHCP server on the
network to automatically assign network settings to the server.
■
For IPv6 configurations, IPv6 stateless auto-configuration is enabled by default, allowing
an IPv6 router on the network to assign the network settings.
In a typical configuration, you will accept these default settings.
Note -
To determine an automatically assigned IP address or host name for your server, use the
network tools provided with the DHCP server or IPv6 router.
54 Sun Server X4-4 Installation Guide • October 2015