–
You are using STA. If you don't select this option, media validation drives
will not show in STA.
–
You are installing a new library. This means host system drive
assignments do not need to be remapped when drives are subsequently
added or replaced.
•
Address Only Installed Drives — Assigns SCSI address to drive bays that
contain an installed drive. Does not address empty drive bays.
Select this if:
–
You are using ACSLS.
–
You are upgrading an SL150 library that does not currently assign
addresses to empty drive bays. Selecting Address Only Installed Drives
retains the current addresses and assigns the next address in sequence
to the new drive.
3.
From the "Drive Auto Clean:" drop-down, select either:
•
On — Enables library auto cleaning. You must have one or two cleaning
cartridges in reserve slots to enable this feature. See
for more information.
•
Off — Disables library auto cleaning. You must configure host-managed
cleaning or manually clean. See
for more
information.
4.
From the "Mailslot Configuration:" drop-down, select either:
•
Standard (4 slots)
•
Expanded (19 slots) — Converts the right magazine of the Base Module
into an additional mailslot. The magazine must be empty before selecting this
configuration. Requires 2.25 code and above.
5.
From the "System Reserved Slots:" drop-down, select the number of slots. If you
are unsure, see
Determine the Required Number of Reserved System Slots
6.
From the "Library Partitioning:" drop-down, select either:
•
Partitioning Off
•
Partitioning On — You will need to partition the library now, see
7.
From the "Library Bridge Drive:" drop-down, select a drive to designate as the
bridged drive. The default bridged drive is Module 1 Top Drive. See
8.
From the "Library Volume Label Format:" drop-down, select a label format. For a
description of each type, see
Partition the Library
Partitioning breaks the library into smaller sections and allows multiple host systems to
access library resources.
Each partition acts as an independent library, but all partitions share the reserved cells,
the single robot, and the four-cartridge mailslot. Partitioning allows multiple hosts to
access the library.
Chapter 4
Run the Configuration Wizard
4-5
