Secure the drive
1.
Secure the drive, as described in your server documentation. The following diagrams are examples only.
Server latch
2
Plastic rail
1
Figure 7 Securing drive, mounting hardware used
M3 screws
1
Figure 8 Securing drive, no mounting hardware used
NOTE:
If you cannot tighten the screws, use washers to secure them.
2.
Ensure blank plates are in place over empty bays and replace the cover on the server.
Reboot the server
Reboot the server to power up the tape drive and server.
Watch the boot screen carefully after installation. If there are any errors or unexpected messages go back and check the SAS
cabling carefully.
•
Have you installed the correct SAS cable?
•
Have you reconnected all devices securely?
If this does not resolve the problem, refer to Troubleshooting (page 29) for further guidelines.
StorageTek LTO Half-Height SAS Tape Drive
13