Oracle SPARC T7-4, Installation Manual

Page: 43 / 90

Install the CMA
■
“Install the CMA” on page 43
■
“Secure Cables Using the CMA” on page 61
Install the CMA
Attach the CMA to the rear posts of the rack.
Note - The CMA installation might block some of the power outlets in the rack, making them
unavailable.
1. Confirm that you have the correct hardware to install the CMA.
See “Determine Correct Rackmount Hardware” on page 35 .
2. Attach the bracket adapters to the CMA comb.
Use six M6 x 6mm screws, three on each side.
3. If the server is already installed in the rack, do the following:
a. Remove the four faceplate screws, two on each side.
Caution -
Do not loosen or remove the screws that secure the shelf rail brackets to the rack.
b. At the rear of the server, on square hole racks, remove the middle adapter
screw on each side.
Installing the Server 43