Oracle SPARC T5-4, Installation Manual

Page: 72 / 92

Installing the OS
72 SPARC T5-4 Server Installation Guide • July 2015
After the system console finishes its low-level system diagnostics, the SP initializes and runs a
suite of higher level diagnostics. When you access the SP using a device connected to the SER
MGT port, you see the output of the Oracle ILOM diagnostics.
By default, the SP configures the NET MGT port automatically, retrieving network
configuration settings using DHCP and allowing connections using SSH.
For a more detailed discussion on configuring the system console and connecting terminals,
refer to the administration guide for your server.
Related Information
■
Servers Administration
■
Oracle ILOM documentation
■
“Configure the Preinstalled OS” on page 72
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 73
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 75
■
“Assign a Static IP Address to the NET MGT Port” on page 80
Installing the OS
Use these topics to either configure the preinstalled OS or use an alternative OS.
■
“Configure the Preinstalled OS” on page 72
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 73
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 75
Related Information
■
“Oracle Solaris OS Configuration Parameters” on page 77
Configure the Preinstalled OS
1.
Determine which OS you will use.
■ If you plan to use the preinstalled OS, proceed to step 2.
■
If you do not plan to use the preinstalled OS, go to “Reach a State to Install a
Fresh OS (Oracle ILOM CLI)” on page 73 .