Oracle SPARC Enterprise M4000, Installation And Service Manual

Page: 148 / 182

C-6 External I/O Expansion Unit for SPARC Enterprise M x 000 Servers Installation and Service Manual • April 2011
C.3 Software Commands for the External
I/O Expansion Unit
From the host server, you can use the following commands to identify and locate the
PCI cards in the I/O boats:
For the following examples of program output, assume an External I/O Expansion
Unit has one PCI Express boat and one PCI-X boat. The boats contain six PCI cards
each:
TABLE C-5
Diagnostic and Maintenance Commands
Command Comments Reference
ioxadm
(8) The
ioxadm
(8) command displays information about the External
I/O Expansion Unit. System administrators and service personnel
can use
ioxadm
to manage External I/O Expansion Unit functions.
TABLE C-7
show-devs
Displays device tree information for PCI cards and other devices
attached to the host. Run this command from the OpenBoot prompt.
EXAMPLE C-1
cfgadm
(1M) The
cfgadm
(1M) command displays dynamic reconfiguration
information for a system. Run this command from the Oracle Solaris
superuser prompt.
EXAMPLE C-2
prtdiag
(1M) The
prtdiag
(1M) command displays system configuration and any
failed field replaceable units (FRUs). Run this command from the
Oracle Solaris superuser prompt.
EXAMPLE C-3
TABLE C-6
PCI Cards in a Typical External I/O Expansion Unit
Boat Slot PCI Card
PCI Express boat 1 Dual gigabit Ethernet
2 Dual gigabit Ethernet
3 Dual gigabit Ethernet
4 4 gigabit fibre channel
5 Dual 4 gigabit fibre channel
6 Dual 4 gigabit fibre channel
PCI-X boat 1 Quad gigabit Ethernet
2 4 gigabit fibre channel
3 Gigaswift gigabit Ethernet