Oracle netra X5-2, Service Manual

Page: 50 / 274

Clear a Fault Manually
The fault history provides the date and time (
TIMESTAMP
) of the fault, the UUID, and the
MSGID of the fault.
In this example, three fault events occurred as indicated in the
MSGID
column. When the fault
was
Repaired
satisfactorily, Oracle ILOM marked the fault as
Resolved
.
5.
Exit the
faultmgmt
shell.
faultmgmtsp> exit
->
Related Information
■
“Display Faults (
show faulty
Command)” on page 47
■
“Clear a Fault Manually” on page 50
■
“Resettable Targets” on page 51
Clear a Fault Manually
If Oracle ILOM detects a fault and consequential component replacement, Oracle ILOM
automatically clears the fault. However, if the host detects a fault, you must manually clear the
fault from Oracle ILOM after resolution by resetting the component.
1. Access Oracle ILOM.
See “Access the SP (Oracle ILOM)” on page 28 .
2. Reset the component to clear the fault manually.
-> set
target
clear_fault_action=true
where target is the Oracle ILOM target of the faulted component.
See “Resettable Targets” on page 51 for a list of targets.
For example, to reset and clear a fault with power supply 0:
-> set /SYS/PS0 clear_fault_action=true
Are you sure you want to clear /SYS/PS0 (y/n)? y
Set 'clear_fault_action' to 'true'
->
Related Information
■
“Display Faults (
show faulty
Command)” on page 47
■
“Display Faults (
faultmgmt
Shell)” on page 48
50 Netra Server X5-2 Service Manual • October 2016