Oracle Fabric Interconnect F1-15, User Manual

Page: 122 / 176

Replace the Fabric Interconnect F1-15 QDR Fabric Board
Caution -
Do not force the Fabric Board into place. If it does not slide in easily, remove it and
attempt to insert it again. Make sure that the leading edges are level, and you are keeping the
Fabric Board level while you slide it in.
10. When the notches and guides are properly positioned, press the Fabric Board's
handles inward to seat the Fabric Board (1) as shown in Figure 78, “Seating the
QDR Fabric Board into a Fabric Interconnect F1-15,” on page 122 . The Fabric
Board is properly seated when it and its handles lie flush against the chassis.
Caution -
Do not force the levers. They should glide easily when properly aligned. If you feel
uneven resistance or the release levers do not move easily, gently swing the levers away from
each other, partially remove the Fabric Board, and attempt Step 8 through Step 10 while paying
attention to how the release levers contact the edge of the chassis.
FIGURE 78 Seating the QDR Fabric Board into a Fabric Interconnect F1-15
11. When the release levers have correctly locked the QDR Fabric Board into the
chassis, use the screwdriver to secure the captive screws in the release levers
(2).
Caution -
When tightening screws, make sure to tighten them to lightly snug. Do not
overtighten screws or they can break.
122 Oracle Fabric Interconnect Hardware User's Guide • July 2016