Servicing the Internal USB Flash Drives (CRU)
Servicing CRUs That Require Server Power-Off
113
3.
Hold the riser in one hand and use your other hand to carefully insert the PCIe
card connector into the riser.
4.
Install the PCIe riser.
For instructions, see
“Install the PCIe Riser Into PCIe Slots 3 and 4” on page 105
.
Servicing the Internal USB Flash Drives (CRU)
Caution -
These procedures require that you handle components that are sensitive to static
discharge. This sensitivity can cause the component to fail. To avoid damage, ensure that you
follow antistatic practices as described in
“Take Antistatic Measures” on page 59
.
Caution -
Ensure that all power is removed from the server before removing or installing a
flash drive or damage to the drive might occur. You must disconnect all power cables from the
system before performing these procedures.
This section covers the following procedures:
■
“Remove an Internal USB Flash Drive” on page 114
■
“Install an Internal USB Flash Drive” on page 115
Related Information
■
Summary of Contents for EXADATA X6-2
