Oracle ATLS2XGF, User Manual

Page: 30 / 86

20 Sun Dual 10GbE XFP PCI Express Card User’s Guide • May 2010
7. Connect the Ethernet cables.
Verifying the Hardware Installation
After you have installed the Sun 10-Gigabit Ethernet adapter, but before you boot
your system, perform the following tasks to verify the installation. Refer to the your
Solaris documentation for the detailed instructions.
Note –
Verification is not required if your system supports dynamic reconfiguration
(DR). Verification is not supported if your system is running Solaris x86 software.
▼
To Verify the Hardware Installation
1. Power on the system, and when the banner appears, press the Stop-A key
sequence to interrupt the boot process and display the OpenBoot (
ok
) prompt.
2. List the network devices on your system.
Checking the
.properties
output for each device is the surest way to identify
the device. Usually
/pci@7c0/pci@0/pci@8
or
/pci@7c0/pci@0/pci@9
correspond to PCIe slots, so look at those devices first.
Note –
If you do not see the device listed, check that the adapter is properly seated.
If necessary, reinstall the adapter.
ok show-nets
a) /pci@7c0/pci@0/pci@8/network@0,1
b) /pci@7c0/pci@0/pci@8/network@0
c) /pci@7c0/pci@0/pci@2/network@0,1
d) /pci@7c0/pci@0/pci@2/network@0
e) /pci@780/pci@0/pci@1/network@0,1
f) /pci@780/pci@0/pci@1/network@0
q) NO SELECTION from the above list
a) /pci@7c0/pci@0/pci@8/network@0,1
b) /pci@7c0/pci@0/pci@8/network@0