Origine
MkII
Owner’s Manual Oracle Audio Technologies
7
-
Delicately position the tonearm over the pivot shaft being extremely careful not to hit the tonearm
base against the tip of the pivot shaft as this would damage it.
Keep your stylus guard on your
phono cartridge for now.
-
Clip the Origine tonearm in the armrest.
-
Connect the tonearm wire harness (the 5 pin green connector) to the 5 pin header at the top of the
RCA output box at the back of the Origine.
Note
:
this is a polarized connector and it can be
connected in only one direction!
Once connected, the wires from the green connector should be
pointing away from the turntable.
-
Make sure that the delicate tonearm wires are free and that they do not get in contact with the RCA
cables or ground cable. Any stress or tension on the tonearm wires will have an impact on the
tonearm
’s free motion and will affect the sound reproduction.
-
Setup the anti-skating weight. One end of the string is already attached to the tracking force stem at
the rear of the tonearm base. Gently lead the anti-skating barrel string up and over the support hook
located at the rear of the tonearm base letting it hang freely. Make sure the string holding the barrel
is not twisted around the tonearm wires! The acrylic barrel itself represents a weight of one gram.
The provided small stainless steel pins each have a mass of 0.25 gram.
-
